Parts List

Using your machine
Filling the water/solution tank and cleaning modes
CAUTION: Always unplug the carpet washer before performing any maintenance/troubleshooting checks.
IMPORTANT: Your dirty water tank is tted with a oat. When the dirty water tank is full, or the oorhead is not in contact
with the carpet, the oat will shut o the suction on the carpet washer. You will be able to hear if this has happened as the
motor noise on the machine will increase. Once the oat is activated, empty the dirty water tank if full. If the dirty water tank
is not full then turn o your machine at the power switch and wait for the oat to settle.
NOTE: Carpets should be dry vacuumed thoroughly before washing. For heavily soiled areas, it may be necessary to repeat
the cleaning process. Make criss-crossing strokes across the original pattern and overlap with each pass.
Press clean water
/solution tank release
button, and pull and lift
to remove tank.
Tilt and line up the front
of the tank with the
washer, and push the
tank back until it clicks
into place.
Turn wash/rinse dial to
‘wash’. The SpinScrub
brushes and brushbar
deep clean your carpets
with water and solution,
removing dirt and stains.
Fill the clean water tank
with warm water
(max 40�C). Fill to max
ll line for a Deep Clean,
and ll to the Quick Clean
ll line for a quick surface
clean.
Pour required amount of
carpet cleaning solution
into tank. Tighten cap
before returning tank
to unit.
Plug into mains and
press the On/O button
to switch on.
Choose the cleaning mode
by turning the dial on the
base.
Quick Clean Mode: Best
for a quick, surface clean
with carpets drying in
less than 1 hour.
Deep Clean Mode: Best
overall results for a
thorough, deep clean.
Twist solution tank
cap anti-clockwise
and remove.
TIP
This machine has an auto mix tank so any
solution not used can be poured back into
the bottle.
Quick Clean Mode: Best for a quick, surface clean because carpets dry in less than 1 hour.
Deep Clean Mode: Best overall results for a thorough, deep clean.