Parts List

Remove the bottom cover (B).

Clean out any debris or hair from

the brushbar and turbine fan.

Clean the TurboTool by removing the

2 screws (A), located on the bottom

cover, with a crosshead screwdriver.

Replace the bottom cover, insert

and tighten the screws.

CAUTION: To reduce the risk of injury from moving parts – unplug before servicing. The brushbar is equipped with

bearings which contain sucient lubrication for their lifetime. Do not add lubricant to the brushbar.

Removing blockages from the TurboTool

IMPORTANT: Remove the accessory from the hose or telescopic extension tube before performing maintenance

or troubleshooting checks.

Let’s talk technical

Cable rewind button is located at the rear

of the machine. After unplugging, press the

cable rewind until the cord is fully retracted.

For convenience there is a parking slot located at the

rear of the vacuum cleaner where the oorhead and

tubes can be attached for storage and carrying.

Storing your machine

Remove the hose from the vacuum

cleaner and telescopic extension tube.

Remove any blockage by inserting a

wire coat hanger into the hose.

Removing blockages from the hose

TIP

To test for a blockage

in the hose, drop a

small ball of paper into

the hose. The paper

will drop through if

the hose is clear.