Specifications

5/9/13 888-2857-001 2-19
WARNING: Disconnect primary power prior to servicing.
Section 2 Installation / Initial Turn-On
Platinum VAX-C Series
STEP 9 Use the LCD screen and control buttons to set RTAC to Adapt mode.
Navigate to Setup>Adaptive>Power on LIN and set to Adapt. Navigate
to Setup>Adaptive>Power on NON-LIN and set to Adapt.
STEP 10 It may take a few minutes for RTAC to adapt and correct the signal.
STEP 11 End of procedure.
2.12 Battery Backup Activation
Units that ship with the optional battery backup (UPS) system installed will have a
connector/jumper installed on the Tx Interface connector on the UAX-C chassis rear
panel.
Figure 2-6 Battery Backup (UPS) Jumper
Once the transmitter has been placed into service the battery backup connector/jumper
can be removed to activate the battery backup (UPS) system. Retain the connector/
jumper for future use should the transmitter be placed in storage or shipped to another
location.