Specifications

2-10 888-2857-001 5/9/13
WARNING: Disconnect primary power prior to servicing.
Section 2 Installation / Initial Turn-On
Platinum VAX-C Series
10MHZ REF INPUT BNC, female connector is the (optional) 10 MHz reference frequency
input. It is used when precise control of the exciter’s pilot frequency is
required. Normal signal input range is -10 to +10 dBm. The input
impedance is 50 ohms.
USER REMOTE 25 pin, female, D sub connector. See pinout in Table 2-3 below.
TRANSMITTER
INTERFACE
25 pin male D sub connector. See pinout in Table 2-4 below.
TS LOOP OUT Female BNC connector is an output sample of the on the air ASI or
SMPTE signal
10/100 Base T RJ45 connector is the rear panel Ethernet connector. This connector can
be set to the DHCP mode.
RF Out 50 ohm, type N, female connector. RF output up to 50 W depending on
model.
Table 2-2 Rear Panel Connections
Connection Description