Specifications

5/9/13 888-2857-001 5-5
WARNING: Disconnect primary power prior to servicing.
Section 5 Maintenance and Alignments
Platinum VAX-C Series
STEP 11 Remove the W9 ribbon cable from the J6 connector on the PA interface
board.
STEP 12 Slide PA module toward front of chassis output until RF output
connector clears the rear of the chassis.
STEP 13 Lift the PA module partially out of the chassis (tip PA interface board
upward).
STEP 14 Disconnect ribbon cable W5 from J5 on the underside of the PA interface
board (see Figure 5-3). The ribbon cable stays connected to the signal
processor board and should be pulled out of the PA section and secured
to keep it out of the way during PA module removal.
STEP 15 Remove the amplifier from the chassis.
STEP 16 End of procedure.