Specifications

5/9/13 888-2857-001 3-61
WARNING: Disconnect primary power prior to servicing.
Section 3 Operation
Platinum VAX-C Series
Figure 3-39 DVB-T Setup Screen 7
.
Table 3-34 Xmtr Home>Exciter Home>Setup>DVB-T Modulator Next x6
(screen 7)
Fields Explanation
The DVB-H configuration sets information in the TPS (Transport Parameter Signaling) bits that
pertain only to DVB-H mode. The programming choices for all four entries are On or Off, see the
following for more information. These parameters can only be set in MFN mode. In SFN mode these fields
display the settings read from the MIP packet.
HP MPE
Encapsulation
Sets TPS bits to indicate if MPE Encapsulation is used with high priority
stream. Programming choices are On or Off.
LP MPE
Encapsulation
Sets TPS bits to indicate if MPE encapsulation is used with low priority
stream. Programming choices are On or Off.
HP Time Slicing Sets TPS bits to indicate if time slicing is used with high priority stream.
Programming choices are On or Off
LP Time Slicing Sets TPS bits to indicate if time slicing is used with low priority stream.
Programming choices are On or Off
RF Output If AND >
MND
Choices are Yes or No. AND = actual network delay. MND = maximum
network delay. Choosing yes allows the transmitter to operate if the actual
network delay exceeds the maximum allowable network delay.
Softkeys
Setup Displays Setup screen.
Exciter Home Displays Exciter Home screen.