Specifications

3-50 888-2857-001 5/9/13
WARNING: Disconnect primary power prior to servicing.
Section 3 Operation
Platinum VAX-C Series
Figure 3-31 ISDB-T Setup Screen 2
ISP Pressing this soft key displays the ISP ’In-System Programming’ Screen
shown in Figure 3-15 on page 3-22. The ISP screen is used to load
software into the transmitter.
Status Displays Status screen.
Setup Displays Setup screen.
Exciter Home Displays Exciter Home screen.
Table 3-26 Xmtr Home>Exciter Home>Setup>ISDB-T Modulator >Next
(screen 2)
Fields Explanation
SFN Mode Choices are MFN (Multiple Frequency Network) or SFN (Single
Frequency Network).
Eqpmnt ID Range is 0 to 63. Equipment ID is assigned by the SFN network
administrator and is provided to allow a unique identifier for each
transmitter in the SFN cell. When the equipment ID in the IIP packet
matches the local equipment ID, then the IIP Time Offset information is
extracted
RF Output if SFN/
IIP Error
Choices are Yes or No. If no is selected, transmitter will be muted if SFN
information is missing from the transport stream or SFN delay
calculations result in negative delays or delays greater than one second. If
yes is selected, the exciter will output RF which is not properly SFN
synchronized.
Table 3-25 Xmtr Home>Exciter Home>Setup>ISDB-T Modulator (screen 1)
Fields Explanation