Specifications

3-48 888-2857-001 5/9/13
WARNING: Disconnect primary power prior to servicing.
Section 3 Operation
Platinum VAX-C Series
TX ID A transmitter ID field used to identify the transmitter. This corresponds
to Cell ID in the GB spec so transmitter control via Cell ID is possible
upstream via the SIP inserter.
DC Test Tone Mode Enabling the DC Test Tone Mode transmits a single tone which is placed
at the center of the spectrum. It is used to measure carrier frequency. The
single tone signal is the same power as the exciter is putting out normally. With
this being the same power level this should not cause any damage to the
transmitter. Disabling the DC Test Tone Mode causes normal transmission to be
resumed
.
Softkeys
Setup Displays Setup screen.
Exciter Home Displays Exciter Home screen.
Table 3-24 Xmtr Home>Exciter Home>Setup>CTTB Modulator>Next>Next
(screen 3)
Fields Explanation