User guide

6vax.co.uk
1
2
Looking after your machine - Filters
Cleaning the HEPA post-motor lter
Cleaning the pre-motor lter
Advanced cleaning - cyclone seperator
WARNING: Filters require cleaning at least every three months. Do not use your vacuum cleaner without all
of the lters in place.
WARNING: Always switch o and unplug the vacuum cleaner from the electrical socket before assembling,
opening or emptying the dirt container, or before connecting/disconnecting the attachments.
NOTE: Wipe to clean. Parts must be completely dry before using your machine.
WARNING: Do not wash the post-motor lter.
tap
24hr
tap
1
IMPORTANT: The motor is equipped with a thermal cut-out. If for any reason the unit should overheat, the thermostat will automatically turn the unit o.
Should this occur, unplug the vacuum cleaner from the electrical socket and turn o the switch. Remove and empty the dirt container. Check the hose
for blockages. Clean the lters. Allow the unit to cool for approximately one hour (if you have cleaned the lters you will need to wait twenty four hours
for the lters to dry before putting them back in the machine). To re-start the machine, plug it into an electrical socket and switch it back on.
40 C max
o
Follow the instructions to unlock the cover to remove the
post-motor lter. Dry clean the post-motor lter and put
back in place.
Dislodge any excess dirt by
gently tapping the post-motor
lter over a bin.
Insert the cover back with the symbols being horizontal.
Follow the instruction to lock the cover until it clicks back
in place
1
2
1
2