User guide

6vax.co.uk
5
Looking After Your Machine – Filters Looking After Your Machine – Filters
Emptying and cleaning the dirt container
Remove dirt container
by pushing down the dirt
container release button and
lifting the dirt container.
Hold the dirt container over a bin and press the dirt release latch
(located at the rear of the dirt container).
Tap excess dirt from the lter. Rinse under a tap and leave to dry for 24 hours.
1
1
2
2
3
3
Hold the dirt container and
twist the lid anti-clockwise.
Hold the dirt container and twist
the lid anti-clockwise.
Hold the container and twist the
inner separator anti-clockwise.
Lift the lid to reveal the
pre-motor lter.
Lift the lid to reveal the
pre-motor lter.
Remove the inner separator
from the container.
Lift out the pre-motor lter.
Lift out the pre-motor lter.
Dislodge any excess dirt by gently
tapping the inner separator over
a container.
4
T
A
P
4
5
MAX
40˚C
5
T
AP
6
24hr
6
Cleaning the pre-motor lter
Cleaning the shroud
1
Unlock
1
2
2
T
A
P
3
Tabs
3
Post motor lter is located in the
left side wheel. Hold the centre of
the wheel and twist wheel cover
anti-clockwise.
With the wheel cover o
the post-motor lter is
easily removed.
Tap all excess dirt o the lter.
Do not wash.
Cleaning the HEPA post-motor lter
Removing blockages from the TurboTool
IMPORTANT: If the air inlet, hose or telescopic tube is blocked, switch o the vacuum cleaner and remove the
blockage(s) before re-starting the vacuum cleaner.
IMPORTANT: The motor is equipped with a thermal cut-out. If for any reason the unit should overheat, the thermostat
will automatically turn the unit o. Should this occur, unplug the vacuum cleaner from the electrical socket and turn o
the switch. Remove and empty the dirt container. Check the hose for blockages. Clean the lters. Allow the unit to cool
for approximately one hour (if you have cleaned the lters you will need to wait twenty four hours for the lters to dry
before putting them back in the machine). To re-start the machine, plug it into an electrical socket and switch it back on.