User guide

6vax.co.uk

Looking after your machine - Filters

Cleaning the HEPA post-motor lter

Cleaning the pre-motor lter

Advanced cleaning - cyclone seperator

WARNING: Always switch o and unplug the vacuum cleaner from the electrical socket before assembling,

opening or emptying the dirt container, or before connecting/disconnecting the attachments.

NOTE: Wipe to clean. Parts must be completely dry before using your machine.

WARNING: Do not wash the post-motor lter.

tap

24hr

tap

IMPORTANT: The motor is equipped with a thermal

cut-out. If for any reason the unit should overheat, the

thermostat will automatically turn the unit o. Should this

occur, unplug the vacuum cleaner from the electrical socket

and turn o the switch. Remove and empty the dirt container.

Check the hose for blockages. Clean the lters. Allow the

unit to cool for approximately one hour (if you have cleaned

the lters you will need to wait twenty four hours for the

lters to dry before putting them back in the machine).

To re-start the machine, plug it into an electrical socket

and switch it back on.

40 C max