User guide

Vax VCC-03
8
clearing blockages/troubleshooting
8. Clearing Blockages
WARNING: To reduce the risk of electrical
shock the power cord must be disconnected
before performing maintenance or troubleshooting
checks.
Turn vacuum cleaner off and disconnect the power plug
from the electrical outlet.
The flexible hose can be disconnected from the vacuum
cleaner by rotating anti-clockwise and pulling away from
the machine. Remove any blockages found then
reconnect the hose.
9. Troubleshooting
WARNING: To reduce the risk of personal injury,
unplug the vacuum cleaner before servicing.
PROBLEM: Vacuum cleaner won't run
Cause:
Not properly plugged into electrical outlet.
Solution: Plug unit in firmly.
Cause: Vacuum cleaner not turned on.
Solution: Press on/off button.
Cause: No electricity in the electrical outlet.
Solution: Check fuse or breaker.
Cause: Blown fuse / tripped breaker.
Solution: Reset circuit breaker or replace fuse.
Cause: Motor thermostat has tripped.
Solution: Switch off and unplug the vacuum cleaner.
Leave for one (1) hour. See page 3.
PROBLEM: Cleaner won’t pick up/loss of suction.
Cause:
Dust bag not installed correctly.
Solution: Review dust bag removal and replacement.
Cause: Dust bag full or blocked.
Solution: Replace dust bag.
Cause: Clogged filter.
Solution: Remove and replace with new filter.
Cause: Blockage in hose.
Solution: Disconnect hose, remove the obstruction
then re-fit.
PROBLEM: Accessories won’t pick up.
Cause:
Accessories not attached correctly.
Solution: Refer to page 7 for fitting information.
PROBLEM: Dust escaping from the vacuum cleaner.
Cause:
Dust bag full.
Solution: Dispose of dust bag, replace with a new one.
Cause: Dust bag not installed correctly.
Solution: Review dust bag removal and replacement.
Cause: Hose not installed correctly.
Solution: Review hose installation.
Cause: Filt
er not installed completely.
Solution: R
eview filter removal and replacement.
!
Fig.8/1
!
Vax VCC-03 User Guide.qxd 8/8/07 16:55 Page 8