Instruction Manual

15
Vax Careline 0870 606 1248
accessories / maintenance
NOTE: Make no more than 2 passes with the solution
or rinse over any one area to prevent over-wetting and
damage to fabric.
If additional cleaning is necessary, wait until the
uphols
tery is completely dry before using the tool again.
Empty recovery tank when the motor sound becomes
higher pitched and there is a loss in suction (see
“Automatic shut-off”, Fig. 4/5).
When finished cleaning, follow “After cleaning”
instructions on page 10 and “After using tool” instructions
on page 14.
7. Maintenance
After Cleaning
Allow carpet or upholstery to dry. To help prevent matting
and r
esoiling the carpet, keep children and pets away from
surface until it is completely dry. If it is necessary to walk
on damp carpet, place towels or white cloths on the traffic
areas. If furniture must be replaced before the carpet is
dry, place plastic or aluminum foil under legs of furniture so
metal slides or wood finishes will not stain the
carpet.
Empty tanks, rinse with clear water and let air dry. Rinse
the recovery tank lid and let air dry. Any unused solution
may be left in the solution container for future use.
Remove lint from filter screen located inside recovery tank.
(Fig.7/1).
Remove lint from filter screen located on bottom of
cleaner (Fig.7/2).
NOTE: When brushes seem to be rotating slowly,
disconnect cleaner from electical outlet and check and
clean this screen
.
Remove both tanks as described in Fig 4/9 & Fig 4/10. Tilt
cleaner back so handle rests on floor.
Squeeze filter frame, lift and pull it out. Wipe off screen
and push frame back into place. Return cleaner to upright
position.
Fig.7/1
Fig.7/2