Operation Manual

Re-setting the brushbar
TIP
When changing the belt, this is
the perfect time to clear any
debris from your brushbar
Let’s talk technical Let’s talk technical
A RED light
will indicate a
jammed brushbar.
Push the machine into
the upright position to
automatically reset
the brushbar.
A GREEN light
indicates no blockages
in the brushbar.
IMPORTANT: If the brushbar, air inlet, hose or telescopic tube is blocked, switch o the
vacuum cleaner and remove the blockage(s) before re-starting the vacuum cleaner.
IMPORTANT: Always switch o your vacuum cleaner at the mains before carrying out any maintenance.
Switch o machine
then unplug. Place the
vacuum cleaner on the
oor and remove the 5
screws on the back of
the brushbar cover.
If the light continues to ash red after resetting, the brushbar may still be blocked. Using a pair
of scissors, cut through any threads or hairs caught around the brushbar. To access brushbar:
Remove the
brushbar cover.
Using a pair of scissors
cut any hair or debris free
from around the brushbar.
Screw the brushbar cover
back on.
Push the machine into the
upright position to automatically
reset the brushbar.
Removing debris from the brushbar
Switch o your vacuum
cleaner at the main socket
and unplug. Place the
vacuum cleaner on the
oor and remove the 5
screws on the back of the
brushbar cover.
Changing the belt
Remove the brushbar
cover and lift the brushbar
from the machine to
access the belt.
Note: To remove debris
from the brushbar see
‘Removing debris from the
brushbar’ opposite.
Lift the belt and slide the
belt o the brushbar.
Unscrew round access
panel and remove.
Remove the belt from the
metal spindle through
access panel located inside
the machine and replace
with the new belt.
Oncethebelthasbeen
replaced, insert the
brushbar back onto
the vacuum.
Attach the brushbar
cover by screwing back
into place.