User guide

Looking After Your Machine -

Removing Blockages

Re-setting the brushbar

Removing debris from the brushbar

A RED  ashing light will indicate a

jammed brushbar.

To reset press the RED button in

the middle of the  oorhead.

A GREEN  ashing light indicates

no blockages in the brushbar.

Place the vacuum cleaner on

the  oor upside down and

remove the screw on the

back of the brushbar cover.

Unclip both clips on the

brushbar cover.

Remove the brushbar cover

and remove and debris, hair

and dirt from the brushbar

and belt.

If the light continues to  ash red after resetting, the brushbar may still be blocked. Using a pair of scissors, cut through any

threads or hairs caught around the brushbar. To access brushbar:

Press the brushbar reset

button again to ensure the

blockage is fully cleared.

Removing blockages from the TurboTool

IMPORTANT: If the air inlet, hose or telescopic tube is blocked, switch o the vacuum cleaner and remove the blockage(s) before re-starting

the vacuum cleaner.

NOTE: Brushbar and belt are not removable