Installation manual
On each ISE did you set the Write-Protect
button to the out (write-enabled) position
and the Run/Ready button to the in
(ready) position? (Installation)
Did you verify that a bus node ID plug
is inserted into each ISE and TF85
tape drive installed in your system?
(Installation)
Did you set the Power-Up Mode switch to
Language Inquiry mode (indicated by a
human proļ¬le)? (Installation)
Did you set the Break Enable/Disable
switch to break enabled (up position)?
(Installation)
Does your system have a TK-series or
TF85 tape drive? If so, did you make sure
the Cartridge Insert/Release handle is
closed (pushed in)? (Installation)
7 Connect Additional Devices to the
System
Did you connect terminals and printers to
the system? (Installation)
Did you connect telephones to the
modems on the system? (Installation)
Did you connect the system to a network?
(Installation)
8 Connect an Expander, If Required
Are you installing an expander with
your system? If so, begin installing the
expander now. When the installation
is complete, return to this checklist.
(Expander addendum or manual, system
Installation)
5