VAX 4000 Model 200 (BA430) Installation Checklist EK–V400H–IN–002 June 1991 Digital Equipment Corporation Maynard, Massachusetts
Getting Started This checklist assumes that your entire system arrived and that you are ready to unpack and place it in its appropriate location. Before proceeding, unpack all cartons and check the contents of each carton against the Product Delivery Document (shipping list). If any item is missing or damaged, contact your delivery agent and your Digital sales representative. Caution: Before you install your system, review the system warranty.
Documents You Will Need Find your Customer Hardware Information Kit. It consists of several manuals and a gray vinyl binder to hold them. To install and use your system, you need the following documents.
1 Verify Site Preparation Is there adequate power for your system and its peripherals? (Site Preparation) Are you allowing enough space for your system? (Site Preparation) Does your site maintain the proper environmental operating conditions? (Site Preparation) Did you gather the tools you will need? (Installation) Are you installing a dual-host system? If so, repeat each step for each system.
4 Open the System Doors Did you find the key to the lock in the shipping carton? (Installation) Did you turn that key to the bottom position to unlock the upper and lower doors? (Installation) 5 Install the Console Terminal Did you unpack the console terminal components? (Terminal installation guide) Did you connect all console terminal components? (Terminal installation guide) Did you turn on the console terminal and observe proper self-tests? (Terminal owner’s manual) Did you perform setup operations for
On each ISE did you set the Write-Protect button to the out (write-enabled) position and the Run/Ready button to the in (ready) position? (Installation) Did you verify that a bus node ID plug is inserted into each ISE and TF85 tape drive installed in your system? (Installation) Did you set the Power-Up Mode switch to Language Inquiry mode (indicated by a human profile)? (Installation) Did you set the Break Enable/Disable switch to break enabled (up position)? (Installation) Does your system have a TK-series
9 Connect the KZQSA Internal Cable, If Required Did you connect one end of the cable to the KZQSA In connector on your system? (Installation) Did you connect the other end of the cable to the upper connector on the KZQSA module? (Installation) 10 Connect the DSSI Cable — Dual Host Only Did you connect one end of the cable to the DSSI In/Out connector on host A? (Installation) Did you connect the other end of the cable to the DSSI In/Out connector on host B? (Installation) 11 Connect the Ground Cable — Dua
13 Turn On the System and Select a Language Did you turn on the console terminal and observe proper self-tests? (Installation) Did you turn on the system by setting the Power switch to on (1)? (Installation) Did you select a language and save it by turning the Power-Up Mode switch to Run mode (indicated by an arrow)? (Installation) 14 Close the System Doors Did you close the front doors? (Installation) Did you turn the key to the middle position to lock both doors or to the top position to leave the upper
S1663 8
