Technical data

The following status message is displayed when the FIS setup
procedure completes.
%UAF-I-RDBDONEMSG, rights database modified
The system then displays messages that remind you to perform certain
tasks after the software is installed:
• Register any Product Authorization Keys (PAKs).
• Back up the system disk.
• Tailor the system disk.
Finally, the system displays the following message, followed by other
status messages.
Running AUTOGEN -- Please wait
At this point the system shuts itself down and then reboots from the
default boot device. The process takes several minutes, and the system
displays a series of information messages:
SHUTDOWN -- Perform an Orderly System Shutdown
.
.
.
VAX/VMS Version Vn.n Major version id = 1 Minor version id = 0
.
.
.
SYSTEM job terminated at 24-JUL-1991 14:47:28.34
Accounting information:
Buffered I/O count: 133 Peak working set size: 401
Direct I/O count: 12 Peak virtual size: 2379
Page faults: 325 Mounted volumes: 0
Charged CPU time: 0 00:00:55.23 Elapsed time: 0 00:01:31.24
6. Press
Return
.
The system prompts you for a username and password.
7. Log in to the SYSTEM account as shown below.
Welcome to VAX/VMS
USERNAME: SYSTEM
Return
PASSWORD: PANCAKES
Return
%LICENSE-I-NOLICENSE, no license is active for this software product
%LOGIN-LOGOPRCON, login allowed from OPA0:
Welcome to VAX/VMS
$
The system prompt ($) indicates the completion of the startup
procedure.
Starting and Modifying VMS Factory-Installed Software A–5