Technical information


Ignition ON

Insert new fuse FB7 and then check the
fuse for proper operation.

Disconnect each of the following
components/control units consecutively
from the wiring harness and repeat the
check each time:
K24 Relay - Starter
S4 Switch - Parking Lamp
S2 Switch - Light
A14 Radio
Y2 Actuator - Circulation
Yes:E14
No:T16
E01
-
Result: Defective Component

Defective component:
A17 Control Unit - Immobiliser
Important:
Reset concerned control unit (engine or immobiliser control unit) with diagnostic
tester before replacing. Select immobiliser in the diagnostic tester and call up the
corresponding test in the menu ADDITIONAL FUNCTIONS. Ensure that both
control units are never reset and replaced at the same time.
E02
-
Result: Interruption

Circuit interruption between:
FB7 Fuse
Output contact
&
A17 Control Unit - Immobiliser
Wiring harness connector (wiring harness side) terminal 5
E03
-
Result: Interruption

Circuit interruption between:
S1 Switch - Starter
Wiring harness connector (wiring harness side) terminal 15
&
FB7 Fuse
Input contact
or

Defective component:
S1 Switch - Starter
E04
-
Result: Interruption

Circuit interruption between:
FL1 Fuse
Output contact
Page
49
of
63
12/25/2005
file://C:\Program%20Files\cosids\DATA\TMP\TmpPrn359232138.HTM