Technical information

Yes:
T03
-
Connect Diagnostic Tester and Establish Communication
Work Order Description Nominal Value
Before connecting the diagnostic tester, observe
the instructions of the diagnostic tester operators
manual

Connect diagnostic tester, select concerned
Electronic System, establish
communication and verify, that the correct
control unit is installed:
Refer to GMPT-E15, Z 22 SE Table B-05
Connect Diagnostic Tester and Establish
Communication

After successful test/fault repair proceed to
the next test step
B-07 - Instrument Check
T01
-
Check: Vehicle Configuration
Is the following information correct for the actual vehicle?
Z 20 LET
Yes:T02
No:T03
Yes:
T02
-
Check: Other system
Work Order Description Nominal Value
Before connecting the diagnostic tester, observe
the instructions of the diagnostic tester operators
manual

Connect diagnostic tester, select concerned
Electronic System, establish
communication and verify, that the correct
control unit is installed:
Motronic
Refer to Motronic M1.5.5, Z 20 LET Table
B-03 Connect Diagnostic Tester and
Establish Communication

Read and record diagnostic trouble codes
including status

If a trouble code with status present is
stored:
Refer to Motronic M1.5.5, Z 20 LET Table
Page
25
of
63
12/25/2005
file://C:\Program%20Files\cosids\DATA\TMP\TmpPrn359232138.HTM