Technical data

OPEL MOVANO (X62)
131 – INTERIOR LIGHTING
Note:
Subject to errors and technical amendments. The electronic version of the body guidelines is the decisive source of
up-to-date data on body guidelines (online body guidelines). Data status June 2009
Before working on the vehicle, refer to chapter 107 “Electrical Connections”.
1. Energy recovery conditions
The progressive ground on connectors is a delayed analogue signal. Under no circumstances may this
signal be relayed.
Excess consumption of no more than 2 A (24 W) may be taken from the rear zone and double cab lighting.
No excess consumption is feasible for front and right-hand side courtesy lights (sliding side door). Follow
the procedure for consumption greater than 2 A.
If consumption is greater than 2 A (24 W) for the rear and double cab lighting and on the front or right-hand
side lighting:
- the delayed power supply should control a relay which will control another power supply.
- a specific ground should be used (the progressive ground will no longer be usable).
If the open door information is required, a panel switch should be added.
N.B.:
For wires with a cross section of 0.5 mm², it is possible to bypass these wires by using a crimp adaptor.
However, for wires with a cross section of 0.35 mm², use of the crimp adaptor is very delicate and it is
strongly recommended to recover this information on the roof connector.
69