Technical data

OPEL MOVANO (X62)

126 – INSTALLATION OF AN ADDITIONAL BATTERY

Note:

Subject to errors and technical amendments. The electronic version of the body guidelines is the decisive source of

up-to-date data on body guidelines (online body guidelines). Data status November 2010

RIGHT HAND DOOR SILL

1 Zone to be cut out from the stamped part for access to the additional battery terminals in the

right-hand cab side sill

2 Radius required regardless of the cut-out

The side sill panel may be cut out to allow access to the positive and negative terminals (see 1).

The maximum authorized cut-out must not exceed the limit of the stamped part. The cut-out will be done

with the radii in the corners (see 2).

The door sill cut-out must be sealed (water, air, noise).

After cutting out the side sill, the filings or shavings must be vacuumed and a corrosion inhibitor used,

referring to the “Specific Corrosion Guidelines”.

To install the additional battery and its mountings, please refer to the “Battery” sheet.

For battery coupling, please refer to the “Battery coupling” sheet.

N.B.:

The additional battery must be disconnected during installation.

Warning:

The batteries may not be directly coupled in parallel.

