Operation Manual

120 Instruments, controls
Odometer display
Top line:
Trip odometer or clock display
3
To switch between the trip odometer and
the clock display 3, press reset button
briefly, see page 119.
Trip odometer
Display of miles covered since reset.
To reset, hold reset button down for
around one second with the ignition turned
on, see page 119.
If the clock display is activated, first switch
to trip odometer.
Time display
3
To adjust the time, setting button in
instrument panel:
Bottom line:
Odometer
Records the miles counted.
Service Display
On vehicles with check control 3, an
appropriate message is shown on the info
display instead of InSP2 and InSP3.
Press for approx. 2 seconds:
Hours flash
Press briefly
Set hours
Press for approx. 2 seconds
Minutes flash
Press briefly
Set minutes
Press for approx. 2 seconds
Clock is started.
InSP Service interval display. Shows
distance remaining to next
service. Further notes, see
page 296.
InSP2 Faulty bulb 3, see page 269.
InSP3 Battery voltage of remote control
or electronic key in Open&Start
system low 3, see pages 34, 39.
InSP4 Drain water from diesel fuel
filter 3. Contact a workshop for
assistance.