Operation Manual

257Self-help, Vehicle care
Picture no: 17252t.tif
4.Screw the compressor air hose to the
connection on the sealant bottle.
5. Fit the sealant bottle into the retainer on
the compressor.
Set the compressor near the tyre in such
a way that the sealant bottle is upright.
6.Remove the valve cap from the defective
tyre.
Picture no: 17253t.tif
7.Screw the filler hose to the tyre valve.
8. The switch on the compressor must be
set to §.
9.Connect the compressor plug to the
accessory socket or cigarette lighter
socket. Accessory socket – see page 107.
To avoid discharging the battery, we
recommend running the engine.
Picture no: 17254t.tif
10. Set the rocker switch on the compressor
to I. The tyre is filled with sealant.
11. While the sealant bottle drains (approx.
30 seconds) the pressure indicator on
the compressor briefly points to 6bar.
Pressure then sinks a gain.
12. All of the sealant is pumped into the
tyre. Afterwards, the tyre is filled with
air.
13.The prescribed tyre pressure – see
page 337 should be reached within
10minutes. Switch off the compressor
when the correct pressure is obtained.