Operation Manual

148 Lighting
Picture no: 17128t.tif
Door-to-door lighting 3
Dipped beam and reverse lights 3
illuminate for around 30 seconds after the
driver exits the vehicle and closes his door.
To activate
1. Switch off ignition.
2.Remove ignition key 3.
3.Open driver’s door.
4.Pull turn signal stalk toward steering
wheel.
5. Close driver’s door.
If the driv er’s door is left open, the lights will
go out after two minutes.
The light is switched off immediately by
inserting the key into the ignition or pulling
the turn signal stalk again with the driver’s
door open.
Picture no: 17129t.tif
Parking lights 3
The front parking light and tail light of one
side of the vehicle can be activated when
parking:
1. Set light switch to 7 or AUTO 3,
2.Ignition off,
3. Move turn signal stalk all the way up
(right parking light) or down (left parking
light).
An acoustic signal sounds and control
indicator O illuminates briefly in the
instrument panel to indicate activation.
To switch it off, switch on the ignition or
move the turn signal stalk in the opposite
direction.
Picture no: 17130t.tif
Instrument illumination,
Information display illumination
Comes on when ignition is switched on.
Brightness can be adjusted when the
exterior lights are on: Push to release
knob k and then turn it clockwise or
anticlockwise and hold until the desired
brightness is obtained.
Display mode 3 – see page134.