Operation Manual

144 Lighting
Picture no: 18445t.tif
Main beam, headlight flash
To switch from dipped beam to main
beam, push stalk forwards.
To switch back to dipped beam, press stalk
forwards again or pull towards steering
wheel.
To activate the headlight flash, pull stalk
towards steering wheel. Main beam is
engaged for the duration of activation.
The blue control indicator C is illuminate d
when main beam or headlight flash is on.
Picture no: 17123t.tif
Automatic dipped beam
activation 3
Light switch to AUTO: Dipped beam comes
on automatically when the engine is
running if outside light conditions warrant
such.
The exterior lights switch off when the
ignition is switched off.
For reasons of safety, the light switch
should always remain in the AUTO
position.
Turn signal lights
To activate, press stalk up or down lightly.
Picture no: 16989t.tif
After operation, the turn signal stalk
returns to its starting position.
If the stalk is moved past the resistance
point, the turn signal light remains on.
When the steering wheel moves back
toward the straight-ahead position, the
turn signal light is automatically
deactivated.
Tap signal: Move stalk to resistance point
and release to activate three flashes from
the turn signals w hen changing lane s or the
like.
Move the stalk to the resistance point and
hold for the turn signals to flash longer.
Switch the turn signal off manually by
moving the stalk slightly.
Stalk up = Right turn signal
lights
Stalk down = Left turn signal
lights