Operation Manual

141Instruments, Controls
Picture no: 16993t.tif
Windscreen wiper
To activate, move stalk up lightly.
The stalk always moves back to starting
position. Shift to next higher or lower level:
move stalk slightly.
Push stalk past resistance point and hold:
the windscreen wiper stages are run
through; an acoustic signal sounds at
position §.
Press stalk down from position §: Single
swipe.
Picture no: 16994t.tif
Adjustable timed interval wipe 3
To se t the wiper interv al to a value between
2 and 15 seconds:
Turn on ignition, move stalk from
position § down, wait for desired interval,
move stalk to interval wipe $.
The interval time selected remains stored
until it is next changed or until the ignition
is turned off.
After turning on the ignition and setting the
stalk to $, the interval is set to 6 seconds.
Picture no: 16995t.tif
Automatic wiping with rain sensor 3:
To activate, move stalk up lightly.
The rain sensor detects the amount of
water on the screen and automatically
controls the wiper.
Keep the rain sensor detection field clear
by activating the screen wash system.
§ =off
$ = timed interval wipe
% =slow
& =fast
$ = automatic wiping with rain sensor
§ =off