Operation Manual

120 Instruments, Controls
Picture no: 17335t.tif.
Odometer display
Top line:
Trip odometer or clock display 3
To switch between the trip odometer and
the clock display3, press reset knob
briefly, see previous page.
Trip odometer
Display of miles covered since reset.
To reset, hold reset button down for
around one second with the ignition turned
on, see previous page.
If the clock display is activated, first switch
to trip odometer.
Tim e d isplay 3
To adjust the time, setting knob in
instrument:
Bottom line:
Odometer
Records the miles counted.
Picture no: 17008t.tif
Service Display
On vehicles with check control 3, a
message is shown on the info display
instead of InSP2 and InSP3.
Press for approx. 2 seconds:
Hours flash
Press briefly
Set hours
Press for approx. 2 seconds
Minutes flash
Press briefly
Set minutes
Press for approx. 2 seconds
Clock is started.
InSP Service interval display. Shows
distance remaining to next
service. Further notes, see
page296.
InSP2 Bulb blown 3, see page 269.
InSP3 Battery voltage of radio remote
control or electronic key in
Open&Start system low3, see
pages 31, 36.
InSP4 Water in diesel fuel filter 3.
Contact a workshop for
assistance.