Operation Manual

114 Instruments, Controls
Picture no: 18444t.tif
R
Brake system , clutch system
Control indicator illuminates or flashes red.
It illuminates after the ignition is turned on,
when the hand brake is applied or if the
brake or clutch fluid level is too low. For
further information see pages 221, 302.
For vehicles with Easytronic 3, the control
indicator flashes for a few seconds when
the ignition is turned off if the hand brake
is not applied.
Picture no:
9 Warning
Lights when the handbrake is released:
stop vehicle immediately. Contact a
workshop for assistance.
v
Airbag systems3, belt tensioners 3,
deployable anti-roll bars 3
Control indicator illuminates red.
Illuminates when the engine is running
Fault in airbag system, belt tensioners or
roll-over protection, see pages87, 98, 104.
v
Electronic Stability Programme
(ESP®
Plus
)3
Control indicator flashes or illuminates
yellow.
Flashing during driving
System actively engaged, see
pages 208,209.
Illuminates while driving
System switched off or fault in system for
Electronic Stability Program, see page 209.
X
Seat belt 3
Control indicator illuminates or flashes red.
Lights when the ignition is turned on, until
the seat belt is fastened. After starting to
drive, the control indicator flashes.
Fasten seat belt, see page88.