Operation Manual

262 Self-help
4. Screw the compressor air hose to the
connection on the sealant bottle.
5. Fit the sealant bottle in the retainer on
the compressor.
Set the compressor near the tyre in such
a way that the sealant bottle is upright.
6. Remove the valve cap from the defective
tyre.
7. Screw the filler hose to the tyre valve.
8. The switch on the compressor must be
set to §.
9. Connect the compressor plug to the
accessory socket or cigarette lighter
socket. Accessory socket – page 107.
To avoid discharging the battery, we
recommend running the engine.
10. Set the rocker switch on the
compressor to I. The tyre is filled with
sealant.
11. While the sealant bottle drains (approx.
30 seconds) the pressure indicator on
the compressor briefly points to 6 bar.
Pressure then sinks again.
12.All of the sealant is pumped into the
tyre. Afterwards, the tyre is filled with
air.
13. The prescribed tyre pressure
– page 333 should be reached within 10
minutes. Switch off the compressor
when the correct pressure is obtained.