Operation Manual

140 Lighting
Door-to-door light function
Dipped beam and reversing lights 3 light
for around 30 seconds after the driver exits
the vehicle and closes his door.
To activate
1. Switch off ignition.
2. Remove ignition key. 3.
3. Open driver’s door.
4. Pull turn signal stalk toward steering
wheel.
5. Close driver’s door.
If the driver’s door is left open, the lights will
go out after two minutes.
Door-to-door lighting can be deactivated
by inserting the key in the starter switch or
by pulling the turn signal stalk toward the
steering wheel again while the driver’s door
is open.
Parking lights 3
The front parking light and tail light of one
side of the vehicle can be activated when
parking:
1. Set light switch to 7 or AUTO 3,
2. Ignition off
3. Move turn signal stalk all the way up
(right parking light) or down (left parking
light).
An acoustic signal sounds and control
indicator O illuminates briefly in the
instrument panel to indicate activation.
To switch it off, switch on the ignition or
move the turn signal stalk in the opposite
direction.
Instrument illumination ,
Information display illumination
Comes on when ignition is switched on.
Brightness can be adjusted when the
exterior lights are on: Push to release knob
k and then turn it clockwise or
anticlockwise and hold until the desired
brightness is obtained.
Display mode 3 – page 58.