Operation Manual

66 Storage
Variable partition net
Insert an adapter into each rail: fold
open the handle plate, insert adapter
into upper and lower groove of rail
and move to required position.
Turn handle plate upwards to lock the
adapter. The rods of the net must be
extended before inserting into the
adapters: pull out all of the end pieces
and lock by rotating clockwise.
To install, push rods together a little
and insert into the relevant openings
in the adapters. The longer rod must
be inserted into the upper adapter.
To remove, press the net rod together
and remove from the adapters. Fold
open the adapter handle plate,
disengage from lower groove and
then from upper groove.
Hooks and mesh pocket
Insert the hooks in the desired
position in the rails: insert the hook in
the upper groove on the rail and press
in the lower groove.
The mesh pocket can be hung from
the hooks.
Safety net
The safety net can be mounted
behind the rear seats or, if the rear
seat backrests are folded down, in
front of the rear seats.
Passengers must not be transported
behind the safety net.
Fitting
There are four installation openings in
the roof frame, two located in front of
and two behind the rear seats.
When fitting behind the rear seats,
remove the load compartment cover
3 63.