Operation Manual

Ligh ting94
Vehi cles w ith level cont rol system
Autom atic headl ight ra ng e a djustment 3
On vehicles with Xenon headlights, the
range of the headlights is adjusted
automatically based on vehicle load.
If control indicator q for automatic
head light range adjustment illuminates in
the instrument cluster while driving, a fault
has occurred.
Have the cause of the fault remedied
immediately. Consult a workshop.
Door-to-door ligh ting
The dipped beam a nd reversing lights
illuminate for app rox. 30 seconds after the
driver exits the vehicle and closes the door.
To activate function:
If the driver’s door is left open, the lights will
extinguish after two minutes.
Door-to-door lighting can be deactivated
by inserting the key in the starter switch or
by pulling the turn signal stalk towards the
ste ering w heel again w hile the driver’s door
is open.
Instrument illumination,
information display illumination
Comes on when ignition is switched on.
Brightness can be adjusted when the
exterior lights are on: turn wheel to the
right or left until the desired b rightness is
obtained.
If driver’s door is opened or q is pressed on
the remote control, instrument panel lights
will illuminate autom atically and stay on
for approx. 30 seconds until starter switch
is turned to the ACC position.
Display mode 3 - see page 83.
z Front seats occupied = 0
z All se ats occ upie d = 1
z All seats occ upied and loa d in
lugga ge c om partment
=1
z Driver’s seat occupied and load
in lugga ge c om partment
=2
1. Switch off ignition.
2. Re mo ve ign ition key .
3. Open driver’s door.
4. Pull turn signal stalk t owards
stee ring whee l.