Operation Manual

Locks, doors, windows24
The remote control unit is used to operate
the anti-theft alarm system.
To activate
Always ensure that the doors, bonnet,
tailgate, sunroof 3 and windows are
properly closed and that there are no
passengers left in the vehicle before
activating anti-theft alarm system.
Press button p on remote control
- or -
Loc k driver’s door by turning key in door
lock towards rear of vehicle then turn it
back to the vertical position and remove;
z Hazard warning lights flash once,
z All do ors are lo cked ,
z Anti-theft system is activated after
approx. 30 seconds.
Confirm that the control indicator starts
flashing slowly, after illuminating for
approx. 30 seconds, to show that the anti-
theft system has been activated.
If button p is pressed aga in, the anti-theft
alarm system will activate automatically,
bypassing the 30 second dela y. This will
also ac tiv ate the mechanica l anti-theft
locking system.
If the hazard warning lights do not flash on
activation or the control indicator fla shes
quic kly, this may indicate that a door, the
tailgate or the bonnet is not fully closed.
Act ivation without monitoring of
passenger compartment and vehicle tilt 3
Switch on when, for example, animals are
to be left in the vehicle.
9 Wa rning
Do not use the system if there are
passengers in the vehicle. The doors
cannot be unlocked from the inside when
the alarm is ac tiv ated and when the
mechanical anti-theft locking system is
activated.
1. Close tailgate and bonnet.
2. Press button a in the roof lining.
Control indicator a illumina tes in
yellow in the instrument cluster.
3. Close doors.
4. Switch on anti-theft alarm system.
Control indicator for anti-theft alarm
system illuminates. After a 30 second
delay, the system is activa ted without
monitoring of the passenger
compartment or vehicle tilt.
Control indicator a rem ains
illumina ted in the instrument cluster
until the system is switched off by
pressing button a again.