Operation Manual

Instruments, controls 89
Autom atic w iping with ra in sensor 3
To activate, mov e stalk upwards to
automatic wiping with ra in sensor
position $ .
The rain sensor detects the amount of
water on the windscreen a nd automatically
reg ulates the windscreen wiper.
The w ip er ope rates for one cy cle to c heck
the system w hen the starter switch is turned
to ACC.
To turn wiper off, mov e stalk to position J.
Ke ep the rain s ensor area clean by
activating the windsc reen wash system .
Further information - see pages 195, 198,
200.
Wi nd sc reen and headlight wash
sy ste ms 3
To activate, pull sta lk towards steering
wheel. Wash fluid is sprayed onto the
wind screen. If the stalk is held longer, the
wiper operates for two cycles after the sta lk
ha s b een released and once more after a
3 second delay 3.
The headlight wash system 3 ca n only be
op erated when the headlights are on.
Wash fluid is sprayed onto the headlights.
The headlight wash system can only be
op erated a gain after a short delay. If wash
fluid level is low then this d elay is increased.
On vehicles fitted w ith ra in sensor 3, kee p
the sensor area clean by activating the
windscreen wash system.
Further inform ation - see pages 195, 198,
200.
Tailgate wi per and wa sh syst em s
Activate wiper and wash as follow s:
Wash fluid is sprayed on to tailgate
window when the button on the end of the
stalk is pressed. When the button is
released, washing will stop, but the wiper
will continue to swipe for approx. 3 c ycles.
Further information - see pages 194, 195,
198, 200.
Wiper on = Push stalk forwards
Wiper off = Pull stalk back towa rd s
steering wheel
Wash = Press and hold button