Operation Manual

Self-help, vehicle care176
3. The location of front and rear jacking
points is indicated by notches on the
bottom edge of the vehicle, under the
doors.
4. Before p ositioning the jack, set it to the
necessary height b y rotating the eye by
han d.
Position jack at the front or rear jacking
point located nea rest to the wheel
concerned so that the ja ck claw spa ns
the vertical base. Mak e sure it is properly
positioned.
The jack b ase must be on the ground
directly below the jacking point in a
manner that prevents it from slipping .
5. Attach wrench to eye of threaded rod
and turn crank to raise vehicle.
If this is not the c ase, carefully low er the
vehicle immediately and reposition the
jack.
Raise the vehicle until the wheel is just
clear of the ground.
6. Unscrew wheel nuts completely by
turning a nticlockwise and wipe clean
with a c loth. Then apply a light coating
of grea se to the cone of each wheel
nut. Do not grease the thread s.
Put whee l nuts s omewhere w here the
threads will not be soiled.