Operation Manual

Self-help176
Picture no: s0013525.tif
Front turn signal lights
1.Open bonnet.
2. Remove hea dlight assem bly.
3. Disconnect wiring harness connector
fro m bu lb h old er.
4. Rotate bulb holder anticlockwise.
5. Pull bulb holder from light assembly.
6. Press bulb inwards and rotate
anticlockwise to remove it from bulb
holde r.
7. Install new bulb into bulb holder by
pressing it in and rotating it clockwise.
8. Reinstall bulb holder in light assembly
and reconnect wiring harness connector.
9. Reinstall headlight assembly.
10. Close bonnet.
Picture no: s0013768.tif
Front fog lights
1. Re move 2 scre ws from panel on
underside of vehicle below front fog
lights and remove panel.
2. Disconnect wiring harness connector
from bulb holder.
3. Rotate bulb holder anticlockwise.
4. Remove bulb holder from light assembly.
5. Rotate bulb anticlockwise and remove
from bulb holder.
6. Install new bulb into bulb holder and
rotate it clockwise.
7. Reinstall bulb holder in light assembly
and reconnect wiring harness connector.
8. Reinstall panel to underside of vehicle
using 2 screws removed earlier.
Picture no: s0013527.tif
Si de rep ea ter lights
1. Using a suitable screwdriver, pry light
assembly away from wing.
2. Rotate bulb holder anticlockwise.
3. Remove bulb from light assembly by
pulling bulb straight out of bulb holder.
4. Install new bulb into bulb holder by
pressing it in and rotating the bulb
holder clockwise.
5. Push light assembly back into aperture.