Operation Manual

Self-help170
Picture no: s0013699.tif
6. Change the wheel.
Notes on spare wheel - see page 166.
7. Screw in wheel bolts and tighten slightly
by hand until wheel is held against the
hub.
8. Rotate wheel bolt wrench anticlockwise
and lower vehicle to the ground.
9. Tighten wheel bolts in criss-cross
sequence, putting the whee l bolt wrench
on as far as possible.
10.Stow the jacking equipment and
warning triangle 3 - see pages 165,
166.
11.Stow replaced wheel in luggage
compartment.
12.Check the tyre pressure of the newly
fitted wheel - see page 207. Adjust as
necessary.
13.H ave the new wheel balanced on the
vehicle and have the tightening torque
of the wheel bolts checked as soon a s
possible, and if necessary, corrected.
Tightening torque - see page 206.
14.Replace defective tyre on the wheel
that was removed.
15.Replace temporary spare wheel with a
full specification wheel without delay.
Electrical sy stem
Fuses
There are two fuseboxes in the vehicle :
the interior fusebox is located on the
left-hand side of the driver’s footwell,
the engine com partment fusebox is
located next to the coolant reservoir on the
right-hand side.
It is ad visab le to ca rry a full s et of fuse s -
available from your Vauxhall Authorised
Repairer.
Spare fuses are kept in the engine
compartment fusebox.
9 Wa rnin g
Electronic ignition systems generate very
high voltages. Do not touch the ignition
system; high voltage can be fatal.