Operation Manual

Lighting 91
Picture no: s0014526.tif
Main beam, headlight flash
To switch from dipped beam to main
beam, push stalk forwards.
To switch back to dipped beam, pull stalk
back towards steering wheel.
To activate the headlight flash, pull stalk
towards steering wheel. Main beam is
engaged for the duration of activation.
The blue control indicator P is illuminated
when main beam or headlight flash is on.
Picture no: s0013591.tif
Automatic dipped beam
activation 3
Light switch to AUTO; dipped b eam comes
on automatically when the engine is
running, depending on outside light
conditions.
For reasons of safety, the light sw itch
should always remain in the AUTO
position.
To ensure automatic dipped beam
activation functions properly, do not cover
the light sensor on top of the instrument
panel.
Picture no: s0014527.tif
Turn sign al lights
To activate, press stalk up or down lightly.
W hen th e s tee ring whee l is tu rn ed back, the
stalk automatically returns to its rest
position. This will not happen when making
a minor steering manoeuvre such as lane
changing.
Tap signal: briefly move stalk to resistance
point. The turn signal then flashes three
times when changing lanes or the like.
Hold the stalk if you want the turn signals
to flash for longer. When released, the stalk
will spring back to rest position.
The volume of the turn signal lights’
audible warning is dependent upon vehicle
speed.
Stalk up = Right turn
Stalk down = Left turn