Operation Manual

Instruments, controls88
Warning buzzers
While driving:
z when operating the turn signals.
z if dr iv er’s o r pas s en ge r’ s se at b e lt 3 is
not engaged when the seat is occupied
and vehicle speed exceeds approx.
14 mph (22 km/h).
When the vehicle is parked and driver’s
door is opened:
z with exterior lights switched on.
z when the key is in the starter switch.
6 Seat belt wa rning chimes -
see pages 42, 68,
driving hints - see page 123,
save fuel, protect the environment -
see page 125.
Picture no: s0013251.tif
Windscreen wiper
To activate, move stalk upwards.
Press stalk down from position J:
single swip e.
Further information - see pages 188, 190,
202.
Picture no: s0013479.tif
Ad just able wi per interval
To set the wiping interval to a value
between 1 and 10 seconds:
Switch on ignition.
Push stalk dow n from position J.
Wait until wiping frequency reaches the
desired interval time.
Set the stalk to adjustable timed interval
wiper position $ .
The interval remains stored until the next
change or the ignition is switched off.
Switching the ignition on and moving the
stalk to $ sets the interval to 3.5 seconds.
In this mode, wiping frequency is also
affected by vehicle speed. As vehicle speed
increa ses, wiping will become more
frequent.
J =Off
$ = Timed interval wipe
% =Slow
& =Fast