Operation Manual

Instruments, controls 67
r
Parking distance sensors 3
Illuminates in yellow when ignition is
switched on.
If it stays illum ina ted while driving, there is
a fault in the system - see page 138.
5
DCS (Descent Control System)
Both control indicators illuminate w hen
ignition is switched on.
Green; illuminates when DCS is ready for
operation. Flashes during driving when
DCS is in operation, after pressing the
DCS button.
Yellow; flashes to indicate system is not
rea dy for conditions to operate.
Illuminates to indicate there is a fault in the
system.
If the yellow control indicator flashes or
illuminates during driving, friction material
needs to cool down: drive the vehicle
without braking as much as possible.
Further information - see page 134.
B
AWD (All Wheel Drive)
Illum inates in yellow when ignition is
switched on.
If it flashes during driving, the AWD system
is temporarily disabled.
If it illumina tes, there is a fault in the
system. Consult a workshop as soon as
possible.
Further information - see page 117.
7
ESP Act ive & Warning
(Electronic Stabil ity Prog ramm e)
see page 132.
A
ESP N ot Ready
see page 132.
J
ESP O FF
see page 132.
q
Automatic headlight range adjustment 3
Illuminates in yellow when ignition is
switched on.
Comes on during driving to indicate a fault
that requires immediate attention. Consult
a workshop as soon as possible.
Further information - see page 93.
W
C ool ant temp era ture
Illuminates in red when ignition is
switched on.
If it illuminates when the engine is running:
stop vehicle and switch off engine. Coolant
temperature is too high; danger of engine
damage. Check coolant level.
Further information - see page 199.
9 Warnin g
Allow engine to cool down before
removing c oolant filler cap.