Operation Manual

Keys, doors, windows24
The remote control unit is used to operate
the anti-theft alarm system.
To activate
Always ensure that the doors, bonnet,
tailgate, sunroof 3 and windows are
properly closed and that there are no
passengers left in the vehicle before
activating anti-theft alarm system.
Press button p on remote control
- or -
Lock driver’s door by turning key in door
lock towards rear of vehicle then turn it
back to the vertical position and remove;
z Hazard warning lights flash once,
z All do ors are locked ,
z Anti-theft system is activated after
approx. 30 seconds.
Picture no: s0013730.tif
Confirm that the control indicator starts
flashing slowly, after illum inating for
approx. 30 seconds, to show that the anti-
theft system has been activated.
If button p is pressed again, the anti-theft
alarm system will activate automatically,
bypassing the 30 second delay. This will
also activate the mechanical anti-theft
locking system.
If the hazard warning lights do not flash on
activation or the control indicator flashes
quickly, this may indicate that a door, the
tailg ate or the bonnet is not fully closed.
Picture no: s0014556.tif
Act ivat ion without monitoring of
passenger compartment and vehicle tilt 3
Switch on when, for example, animals are
to be left in the vehicle.
9 Wa rning
Do not use the system if there are
passengers in the vehicle. The doors
cannot be unlocked from the inside when
the alarm is activated and when the
mechanical anti-theft locking system is
activated.
1. Close tailgate and bonnet.
2. Press button a in the roof lining.
Control indicator a illuminates in
yellow in the instrument cluster.
3. Close doors.
4. Switch on anti-theft alarm system.
Control indicator for anti-theft alarm
system illuminates. After a 30 second
delay, the system is activated without
monitoring of the passenger
compartment or vehicle tilt.
Control indicator a remains
illuminated in the instrument cluster
until the system is switched off by
pressing button a again.