Operation Manual

Self-help, vehicle care184
Picture no: s0013768.tif
Front fog lig hts
1. Remove 2 screws from panel on
underside of vehicle below front fog
lig hts and remove panel.
2. Disconnect harness connector from bulb
holder and rotate bulb holder
anticlockwise.
3. Remove b ulb holder from light assemb ly ,
rotate bulb anticlockwise and remove
from bu lb hold er.
4. Install new bulb into bulb holder a nd
rotate it clockwise.
5. Reinstall bulb hold er in light assembly
and reconnect harness connector.
6. Reinstall panel to underside of vehicle
using 2 screws removed earlier.
Picture no: s0013527.tif
Side repeater lights
1. Using a suita ble screwdriver, pry light
assembly away from wing.
2. Rotate bulb holder anticlockwise.
3. Remove bulb from light assembly by
pulling bulb straight out of bulb holder.
4. Install new bulb into b ulb holder by
pressing it in and rotating the bulb
holder clockwise.
5. Push light assembly back into aperture.
Picture no: s0013528.tif
Rear bra ke, tail, turn signal, reverse lights
and fog tai l light
1. Open the tailgate and remove 2 sc rews
and light assembly.
2. Remove bulb holder by rotating it
antic lockwise.
3. Remove bulb from bulb holder by
pressing the bulb in and rotating it
antic lockwise.
4. Install new bulb into bulb holder.
5. Reinsta ll bulb holder into light assembly.
Rotate bulb holder clockwise and ensure
it is secure.