Operation Manual

Driv in g and op e ra tio n156
Picture no: 18454S.tif
Attach the pedal crank by rotating the
attachment screw on the pedal crank
mount.
Picture no: s0014518.tif
Place the wheel recesses such that the
bicycle is more or less horizontal. Here, the
distance between the pedals and the
tailg ate should b e at least 5 cm . Setting the
whee l recesses - see pa ge 154.
Both bicycle tyres must be in the wheel
recesses. In order to prevent damage,
neither the pedal bearing housing on the
bicycle nor the pedal crank should be
touching the pedal crank recess.
Picture no: s0014519.tif
Align the bicycle in the longitudina l
direction of the vehicle:
Slightly loosen the pedal bearing mount -
see page 153, Fig. 14629 S.
Place the bicycle upright using the rotary
lever on the ped al crank recess -
see page 153, Fig. 14629 S or page 154,
Fig. 14630 S.
If the two bicycles obstruct one another,
the relative positions of the bicycles can be
adapted by adjusting the wheel recesses
and the rotary lever on the pedal crank
recess until the bicycles no longer touch
one another. Make sure there is sufficient
clearance from the vehicle.