Extra Information

82 Phone
control the system. The system can
be used while the ignition is in ON/
RUN or ACC/ACCESSORY.
The range of the UHP system can be
up to 33 ft. Not all phones support all
functions and not all phones work with
the UHP system.
Other information
The Bluetooth word mark and logos
are owned by the Bluetooth
®
SIG, Inc.
and any use of such marks by
General Motors is under license.
Other trademarks and trade names
are those of their respective owners.
UHP controls
Use the buttons located on the
infotainment system and the steering
wheel to operate the UHP system.
Steering wheel controls
Steering wheel controls can be used
to:
■ Answer incoming calls.
■ Confirm system information.
■ Start voice recognition.
■ End a call.
■ Reject a call.
■ Cancel an operation.
■ Make outgoing calls using the call
list.
3 (Push To Talk): Press to answer
incoming calls, to confirm system
information, and to start voice control.
Press and hold for two to three
seconds to access the call list.
4 (End call/mute): Press to end
a call, reject a call, or to cancel an
operation.
To make outgoing calls using the call
list:
1. Press the 3 button.
2. Highlight the phone number by
toggling the SRC switch up or
down.
3. Dial the highlighted number by
pressing the 3 button.
Infotainment system controls
:: Press to enter the Phone main
menu.
Voice control
The voice control system uses
commands to control the system and
dial phone numbers.
Noise: The system may not recognize
voice commands if there is too much
background noise.
When to speak: A tone sounds to
indicate that the system is ready for
a voice command. Wait for the tone
and then speak.
How to speak: Speak clearly in a calm
and natural voice.
Audio system
When using the UHP system, sound
comes through the vehicle's front
audio system speakers and overrides
the audio system. Use the VOL/m
knob during a call to change the
volume level. The adjusted volume
level remains in memory for later
calls. The system maintains
a minimum volume level.
Turning Bluetooth on or off
1. Press the CONFIG button.
2. Press : on a navigation radio.