Operation Manual

In brief 17
Stop-start system
If the vehicle is at a low speed or at a
standstill and certain conditions are
fulfilled, activate an Autostop as
follows:
Depress the clutch pedal
set the lever in neutral
release the clutch pedal
An Autostop is indicated by the
needle at the AUTOSTOP position in
the tachometer.
To restart the engine, depress the
clutch pedal again.
Stop-start system 3 120.
Parking
Always apply the parking brake.
Activate the manual parking brake
without pressing the release button.
Apply as firmly as possible on a
downhill slope or uphill slope.
Depress foot brake at the same
time to reduce operating force.
Switch off the engine. Turn the
ignition key to position 0 and
remove it. Turn the steering wheel
until the steering wheel lock is felt
to engage.
If the vehicle is on a level surface or
uphill slope, engage first gear
before switching off the ignition. On
an uphill slope, turn the front
wheels away from the kerb.
If the vehicle is on a downhill slope,
engage reverse gear before
switching off the ignition. Turn the
front wheels towards the kerb.
Lock the vehicle with button e on
the radio remote control.
Activate the anti-theft alarm system
3 24.
Do not park the vehicle on an easily
ignitable surface. The high
temperature of the exhaust system
could ignite the surface.
Close the windows.
The engine cooling fans may run
after the engine has been switched
off 3 150.
After running at high engine speeds
or with high engine loads, operate
the engine briefly at a low load or
run in neutral for
approx. 30 seconds before
switching off, in order to protect the
turbocharger.
Keys, locks 3 18, Laying the vehicle
up for a long period of time 3 149.