Owner`s manual

State Programming Note: You are simply changing to the state to be programmed, entering the commands to configure the state
however you wish, and then exiting program mode by changing back to State-0. This configuration can be done interactively (ie:
manually selecting routes, adjusting volumes, etc), or it may be just a series of commands from the control system. For example we
will program state-2 for all switchers on the daisy-chain, for a paging application using source-16 to page on zones 1, 2, and 4:
*CW,90,0,0,0,2,0,0 <cr> Change all switchers quickly to State-2
*CW,9,0,0,0 <cr> Fast-Route to turn all zones off (clear the state)
*CW,9,1,16,0 <cr> Fast-Route to select audio source-16 on zone-1
*CW,9,2,16,0 <cr> Fast-Route to select audio source-16 on zone-2
*CW,9,4,16,0 <cr> Fast-Route to select audio source-16 on zone-4
*CW,22,1,40,0 <cr> Fast Volume set to 40% on zone-1
*CW,22,2,50,0 <cr> Fast Volume set to 50% on zone-2
*CW,22,4,45,0 <cr> Fast Volume set to 45% on zone-4
*CW,90,0,0,0,0,0,0 <cr> Restore all switchers quickly to State-0
This sequence of commands can be easily issued by the control system to program this state, provided you have an idea what it should
be ahead of time. In a paging application, you will likely need to manually tweak the zone volumes to proper final paging levels for
each zone – but this can easily be fine-tuned during installation by changing to the state, adjusting the volumes in each zone and exiting
to state-0.
To program the state manually, you just need to provide the commands to enter and exit the state-program mode, and leave all other
configuration to the installer, who will manually route and adjust volumes.
*CW,90,0,0,0,2,0,0 <cr> Change all switchers quickly to State-2
(manual routes/volumes)
*CW,90,0,0,0,0,0,0 <cr> Restore all switchers quickly to State-0
Lattis Matrix Switcher 23 Software Version 7.3.0.0