Owner`s manual

Audio/Video Operation with the RC-16
For all operations below, change the RC-16 remote control to the desired zone, if needed. The remote also needs to be in a/v mode for
the following operations: press the RC-16's a/v mode button to change to a/v mode (the button will flash twice). Note: the remote is
automatically placed in a/v mode when you press certain buttons.
Setting the RC-16’s Current-A/V-Zone:
· For all operations below, set the RC-16 remote so you are controlling the desired zone (01 to 90). Press the Zone button,
followed by two-digits corresponding to the desired zone -- eg: Zone-0-1 will select zone 01, and Zone-1-2 will select zone
12. This zone is saved until you change it again.
· You may also control a Cluster (a group of multiple zones that is programmed into the Lattis system), by selecting zones 91 to
98, for Clusters 1 to 8. Only certain functions are available during Cluster operation.
· You may also choose zone 00, which is a special All-Zones code. Only certain functions are available during All-Zones
operation.
· Note: the remote is automatically placed in a/v mode when you press the zone button.
Selecting a Source:
· Press an RC-16 Source button (Tuner, CD...)
Note: This will automatically place the remote in A/V mode.
· The Lattis Ack light will flash. The source is routed to the zone at the programmed Initial-Volume-Level for the zone (or, the
Previous-Volume, if the zone is so configured). If the zone is currently on, the new source will be at the current volume level.
· The Lattis Active light will be on when any zone is in use.
· If the Lattis s Nak light flashes, the requested zone is not valid for this Lattis unit. (eg: selecting zone 09 when only 01 to 08
are valid in an 8x8 switcher).
· If you have a 16-source LE-1600A or LE-1600V, you access the upper sources by pressing the Shift button, followed by a
source button:
button selects button selects
tuner source 1 shift-tuner source 9
cd source 2 shift-cd source 10
dss source 3 shift-dss source 11
vcr1 source 4 shift-vcr1 source 12
vcr2 source 5 shift-vcr2 source 13
dvd source 6 shift-dvd source 14
tape source 7 shift-tape source 15
aux source 8 shift-aux source 16
Turning the Zone Off:
· Press the RC-16’s On/Off button -- the Lattis Ack light flashes, and the zone turns off (note: pressing the On/Off button
again turns the zone on with the previous source).
· If the Lattis Nak light flashes, the requested zone is not valid for this Lattis unit.
Lattis Matrix Switcher 15 Software Version 7.3.0.0