Owner`s manual

Lattis Matrix Switcher Front Panel
Power Switch
Infrared Contol Sensor (below switch, left of logo)
Power light
Active light (one or more zones on)
Ack light (acknowledge – command accepted)
Nak light (negative acknowledge – command ignored)
Prog light (power-up testing and program-mode)
Lattis Matrix Switcher Rear Panel
A/V Source Inputs (phono jacks) — 4/8/16 inputs for line-level stereo audio (& composite video on 800AV/1600V).
A/V Zone Outputs (phono jacks) — 4/8/16 outputs for line-level stereo audio (& composite video on 800AV/1600V).
The audio outputs are volume/bass/treble/mute controlled within the Lattis Matrix Switcher and connect to
zone power amplifiers (sized appropriately for each zone).
Optional, one or two 40-conductor ribbon cables for daisy-chaining audio sources.
IR-In jack (3.5mm phone) for connection of IR-Repeater system, or other modulated IR input.
Memory-Erase button. Careful — will restore all programmable parameters to factory settings.
I/O connector (8P8C): System-Active (5V) output. Paging contact-closure input. Other connections for future use.
Ctrl-Out connector (6P6C) Expansion port for RS-232/IR daisy-chaining to Ctrl-In connector on next switcher.
Ctrl-In connector (6P6C) (see Ctrl-Out).
Control connector (9-pin DB-9-F) RS-232 serial control port..
Power connector (2.1mm connector, auto-polarity) For 12 VDC, 1 A adapter.
Lattis Matrix Switcher 10 Software Version 7.3.0.0