Owner`s manual

Request-Command & Status-Message Summary:
Status-Message are sent in response to above Control-Commands, but system status may also be
determined at any time (by polling) using these optional Request-Commands (zon=0 not allowed).
Coding Tip: You probably do not need to need to use these commands, in most applications!
Request-Command Description Command Status-Message
Get Zone-Status *CR,1,zon <cr> !S,1,zon,sta,stv,ssa,ssv,vvl,vvr,bas,trb <cr>
Get Audio/Video ssa/ssv route source *CR,10,zon <cr> !S,10,zon,ssa,ssv <cr>
Get Audio Source ssa route source *CR,11,zon <cr> !S,11,zon,ssa <cr>
Get Video Source ssv route source *CR,12,zon <cr> !S,12,zon,ssv <cr>
Get Left/Right Volumes vvl/vvr *CR,20,zon <cr> !S,20,zon,vvl,vvr <cr>
Get Left Volume vvl *CR,21,zon <cr> !S,21,zon,vvl <cr>
Get Right Volume vvr *CR,22,zon <cr> !S,22,zon,vvr <cr>
Get Bass/Treble bas/trb *CR,40,zon <cr> !S,40,zon,bas,trb <cr>
Get Audio Mute state *CR,50,zon <cr> !S,50,zon,sta <cr>
Configuration-Commands & Configuration-Message Summary:
Coding Tip: In many applications, the factory settings are just right – you may want to tweak Initial Volumes.
Config-Write-Cmd Description Command Factory setting
Write controller's Base Zone *PW,1,bzn <cr> 1
Write Minimum-Volume-Level *PW,10,zon,vll <cr> 0 (-64 dB)
Write Maximum-Volume-Level *PW,11,zon,vhh <cr> 32 (0 dB)
Write Initial-Left-Vol-Level *PW,12,zon,vil <cr> 22 (-20 dB)
Write Initial-Right-Vol-Level *PW,13,zon,vir <cr> 22 (-20 dB)
Write Mute-Volume-Level *PW,14,zon,vmm <cr> 0 (-64 dB)
Write Bass-Level *PW,15,zon,bas <cr> 4 (0 dB)
Write Treble-Level *PW,16,zon,trb <cr> 4 (0 dB)
Write Zone Mode *PW,17,zon,mod <cr> 1 (stereo)
Write Taper-Up-Delay *PW,18,zon,tud <cr> 20 (ms/2-dB-step)
Write Taper-Down-Delay *PW,19,zon,tdd <cr> 5 (ms/2-dB-step)
Write Config-Table *PW,30,zon,vll,vhh,vil,vir,vmm,bas,trb,mod,tud,tdd <cr>
Config-Read-Cmd Description Command Config-Message
Read controller's Base Zone *PR,1 <cr> !C,1,bzn <cr>
Read Minimum-Volume-Level *PR,10,zon <cr> !C,10,zon,vll <cr>
Read Maximum-Volume-Level *PR,11,zon <cr> !C,11,zon,vhh <cr>
Read Initial-Left-Vol-Level *PR,12,zon <cr> !C,12,zon,vil <cr>
Read Initial-Right-Vol-Level *PR,13,zon <cr> !C,13,zon,vir <cr>
Read Mute-Volume-Level *PR,14,zon <cr> !C,14,zon,vmm <cr>
Read Bass-Level *PR,15,zon <cr> !C,15,zon,bas <cr>
Read Treble-Level *PR,16,zon <cr> !C,16,zon,trb <cr>
Read Zone Mode *PR,17,zon <cr> !C,17,zon,mod <cr>
Read Taper-Up-Delay *PR,18,zon <cr> !C,18,zon,tud <cr>
Read Taper-Down-Delay *PR,19,zon <cr> !C,19,zon,tdd <cr>
Read Config-Table *PR,30,zon <cr>
!C,30,zon,vll,vhh,vil,vir,vmm,bas,trb,mod,tud,tdd <cr>
10